Best Boot Dryers for Wet Work Boots

Top pick: PEET Original for work boots that get soaked every shift

Buy the PEET Original if your work boots come off wet five days a week and go back on the next morning. It is a thermal convection dryer. PEET rates it at 36 watts, it has no fan and no moving parts, and the maker says it is safe on leather, rubber, vinyl, neoprene and canvas. PEET gives 4 to 8 hours, or overnight, for convection drying of most boots. That fits a boot that comes off at 5 p.m. and goes back on at 6 a.m. PEET’s instructions say to keep at least 6 inches of clearance between the top of the footwear and the base, keep the air vents free, never put footwear on the tubes without the DryPort attachments (that can make the dryer overheat), leave every tube uncovered even when drying one item, and keep the dryer away from a second heat source such as a furnace register.

Get PEET Original

The PEET Original was chosen on five criteria: drying method, time to dry, fit for tall boots, heat level safe for leather, and price. It comes out ahead on the three that matter most for daily work boots. Its convection heat is gentle enough that PEET calls it safe on every footwear material. Its drying time fits the gap between shifts. It is cheap to own: PEET designs it to stay plugged in all the time, and 36 watts for eight hours uses 0.288 kWh, about 5 cents at 17 cents per kWh. PEET lists a 25-year warranty on the Original, and it typically sells for about $50-60.

Who should not buy it: anyone with one pair of boots and fewer than 4 hours between shifts, anyone who also needs gloves dried, and anyone with boots taller than 11 inches who does not want extension tubes (PEET’s page for the Original says its 12-inch extensions are required above that height; its FAQ puts the line at 10 inches). PEET says drying time depends on material and saturation level, so a leather boot that took on water over the collar can take longer on a 36-watt convection unit. In that case one of the fan dryers below does the job better. These picks were not tested. The ranking comes from what the makers’ specifications and retail listings show.

Fastest drying: DryGuy Force Dry DX and PEET Advantage Plus

The DryGuy Force Dry DX is the pick for crews that need boots and gloves dry in the same day. DryGuy rates it at two pairs of boots, shoes or gloves (four items at once) in 1 to 2 hours. It uses a fan and heat capped at 105°F (40.5°C), with a 3-hour timer and a switch for heat or no heat. Buy it if you work split or back-to-back shifts, plough snow and need dry gloves by lunch, or share a mudroom with a second worker. It typically sells for about $115-130. Skip it if you want silence: it has a blower. DryGuy also publishes no wattage figure, so its running cost cannot be worked out from the spec sheet.

Get DryGuy Force Dry DX

The PEET Advantage Plus is a PEET fan model, and the better buy if you want published power figures and a gentle mode for good leather. PEET lists fan plus heat at 220 watts for a 1 to 4 hour turnaround, and an unheated setting that PEET lists at .33 amps. It holds two pairs and has a built-in timer. PEET rates it for standard 110-120 volt U.S. household current, says a voltage reducer may be required in other countries and that it is not responsible for any resulting overheating or damage, and its instructions say to keep the rear air vents clear, keep at least 6 inches between the top of the footwear and the base, never put footwear on the tubes without the DryPort attachments (that can make the dryer overheat), and keep it away from a second heat source such as a furnace register. At full heat, 4 hours uses 0.88 kWh, about 15 cents at 17 cents per kWh. It typically sells for about $130. Buy it over the Force Dry DX if you dry expensive full-grain leather boots and want published power figures; both dryers have an unheated setting. Buy the DryGuy instead if gloves are half the load, because DryGuy states a 105°F heat cap and PEET gives no temperature figure for the heated mode.

Get PEET Advantage Plus

Neither fan dryer is worth the extra $60-80 over the PEET Original if your boots always get a full night to dry. The fan buys you hours, not a drier boot by morning.

Budget picks: JobSite Silent Boot Dryer, JobSite Mighty Dry and DryGuy Simple Dry

The JobSite Silent Boot Dryer is the cheapest convection dryer here worth buying. JobSite rates it at 36 watts with no motor, and gives these drying times: 15 minutes to warm up, 8 hours for damp boots, 12 hours for wet ones. It carries a 2-year replacement warranty and typically sells for about $40-45. JobSite’s manual says to plug it into a 110-120V household outlet only (a higher-voltage outlet will damage it and could cause a fire), never on the same circuit as other appliances; never to let the inside of the dryer get wet; use it on a solid, hard, flat surface, never on carpet, near flammable materials, near other heat sources or outdoors; keep at least 8 inches of clearance from the top of the boot to the base; never use it near children or pets and always with adult supervision; not touch the drying tubes until 30 minutes after it is powered off; never dry items with chemical residue; check drying items often to avoid over-drying; and unplug it when not in use. Buy it for boots that are damp from sweat or a short spell of rain. Do not buy it for boots that come off soaked at 6 p.m. and must be dry by 5 a.m.: the maker’s own 12-hour figure for wet boots does not fit that gap. Spend the extra on the PEET Original for the longer warranty.

Get JobSite Silent Boot Dryer

The JobSite Mighty Dry is the low-cost fan dryer. JobSite lists 200 watts, fan-forced air at 98-110°F and drying in as little as 1 hour. It typically sells for about $45-66, depending on the bundle. JobSite says to set it on a flat, stable surface, plug it into 110-120 V AC, and unplug it when finished. Buy it if you want fan speed and the Force Dry DX is over budget. Note that its 110°F upper figure is 5°F above DryGuy’s 105°F cap. If your boots are oil-tanned or full-grain leather you want to keep supple, the DryGuy’s lower ceiling is worth paying for.

Get JobSite Mighty Dry

The DryGuy Simple Dry is a single-pair convection dryer that also takes gloves. DryGuy says it dries most boots and shoes in 8 hours or less and lists extra-tall drying ports. Retailers sell it for about $45-50. Buy it over the JobSite Silent Boot Dryer if you want the taller ports and glove drying in a fanless unit. Buy the PEET Original instead if the dryer will run every night for years.

Get DryGuy Simple Dry

Tall boots, loggers and rubber boots: PEET XL Tall and extension tubes

Shaft height decides whether warm air reaches the toe box. Standard 6-inch and 8-inch work boots sit well on any dryer here. Above that, PEET says its 12-inch extension tubes are needed for any boot taller than 10 inches, which covers most loggers, wellingtons and knee-high rubber boots. Without the extra reach, the top of the shaft dries and the toe stays wet.

The PEET XL Tall is the same 36-watt convection dryer as the Original, sold with 1 pair of 12-inch extensions for taller boots such as knee boots and hip boots. PEET says the extensions can be removed to dry standard height footwear. It typically sells for about $65-75. Buy the PEET XL Tall if every pair you own is a logger or a rubber boot. PEET rates it for standard 110-120 volt U.S. household current, says a voltage reducer may be required in other countries, and says it is not responsible for any resulting overheating or damage. If you wear a mix of 6-inch boots and tall rubber boots, buy the Original and add PEET’s 12-inch extensions only for the tall pairs.

Get PEET XL Tall

The JobSite brand sells extension tubes that add 8 inches of height and fit both the JobSite Silent Boot Dryer and the JobSite Mighty Dry. A single pack is about $20 and a two-pack about $25. The Force Dry DX comes with two removable extension tubes for boots up to 16 inches tall, and DryGuy sells a Force Dry DX Boot Accessory (SKU 02132) that dries an additional pair of 16-inch boots, for a total of 2 pairs of taller boots at once. Rubber boots trap moisture because the shell does not breathe. On a convection unit, plan on the full overnight cycle for them, not the short end of the maker’s range.

Convection or forced air: drying time, heat and leather

A convection dryer warms air in its base. The warm air rises up the tube into the boot and carries moisture out of the collar, with nothing moving. It is silent and usually draws 36 watts: the PEET Original and the JobSite Silent Boot Dryer both publish that figure. The cost is time. PEET gives 4 to 8 hours and JobSite up to 12 hours for wet boots.

A forced-air dryer pushes heated air down the tube with a fan. The makers’ times drop to 1 to 2 hours for the DryGuy Force Dry DX and 1 to 4 hours for the PEET Advantage Plus. Power rises with speed: the Advantage Plus is rated at 220 watts with heat and the JobSite Mighty Dry at 200 watts. Fan units come with timers (3 hours on the Force Dry DX).

Leather is where heat matters. The published ceilings here run from 105°F on the DryGuy to 110°F on the JobSite Mighty Dry. That is a different kind of heat from a forced-air heater vent or a wood stove, where leather goes stiff and cracks at the toe flex. A boot dryer at those figures dries from the inside without cooking the outside. If your boots are soaked through every day, the leak is the real problem: the best waterproof work boots guide covers boots with membranes that keep water out to begin with.

What is not worth the money, and how to get boots dry by morning

Not worth the money: a fan dryer at about $115-130 for one person with one pair and a full night between shifts. The PEET Original at about $50-60 gets the same boot dry by morning, silently, for about 5 cents a night. Also not worth it: a four-pair commercial wall unit for a single worker. Two ports covers one pair of boots, and the two-pair fan units cover a household.

To get a soaked pair dry by morning, open the laces fully and pull out the removable insoles so the tube reaches the toe box. Dry the insoles on a second port or flat beside the dryer. On a convection unit, put the boots on as soon as they come off: JobSite gives a 15-minute warm-up and 8 hours for damp or 12 hours for wet boots. On a fan unit, set the timer to the longest cycle (3 hours on the DryGuy Force Dry DX) for a boot that took on water over the top.

Expect a smell from a new JobSite Silent Boot Dryer. JobSite’s troubleshooting guide says the ceramic heating resistors give off an odour like a hair dryer for the first 1 or 2 uses, and that it then goes. JobSite says its drying tubes can become hot in use and that this is normal; unplug the unit immediately if you see smoke or signs of melting plastic. A boot that is still wet after the maker’s longest stated time (8 hours for the Original by PEET’s figure, 12 for the JobSite Silent Boot Dryer) can mean a blocked tube or a tall boot with no extension: PEET says every tube must stay unobstructed and that boots taller than 11 inches need its 12-inch extensions.

FAQ

Will a boot dryer damage leather work boots?

Not at the temperatures these makers publish. PEET says its convection dryers are safe on leather, rubber, vinyl, neoprene and canvas, and DryGuy caps the Force Dry DX at 105°F. What cracks leather is high direct heat from a stove or heater vent, not a 36-watt dryer warming the inside of the boot.

How long does a boot dryer take to dry soaked work boots?

A convection dryer takes a night. PEET gives 4 to 8 hours or overnight for the PEET Original, and JobSite gives 12 hours for wet boots on the JobSite Silent Boot Dryer. Fan dryers are faster: DryGuy rates the Force Dry DX at 1 to 2 hours, and PEET rates the Advantage Plus at 1 to 4 hours with heat.

Can a boot dryer stay plugged in all the time?

A convection model is built for it. PEET designs the Original to stay plugged in all day, every day, and at 36 watts it uses about 0.29 kWh in 8 hours. Fan models such as the DryGuy Force Dry DX run on a timer (3 hours on that model).